Particulate Respirator

Filtering half masks meet the requirements of Regulation (EU) 2016/425 and are CE marked accordingly. They have been tested according to EN 149:2001+A1:2009 FFP2 NR. CE Certification body:CCQS Certification Services Limited, Block 1 Blanchardstown Corporate Park, Ballycoolin Road, Blanchardstown, Dublin15, D15 AKK1, Ireland (NB 2834).

The EU Declaration of Conformity can be downloaded from the following website: www.shengquan.com

USER INSTRUCTION
① Failure to follow all instructions and limitations could seriously reduce the effectiveness of this particle half mask and could lead to illness, injury or death.
② A properly selected respirator is essential, before occupational use, the wearer must be trained by the employer in the correct use of the respirator in accordance with applicable safety and health standards.
③ This particle half mask does not supply oxygen. Use only in adequately ventilated are as containing sufficient oxygen to support life.
④ Discard the respirator and replace with a new one if:
a）Excessive clogging of the particle half mask cause breathing difficulty.
b）The particle half mask become damaged.
⑤ Leave the contaminated area if dizziness, irritation or other distress occurs.

FITTING INSTRUCTION
① Place fingers inside the particle half mask. Bend the nose clip around fingers to form nose shape.
② Hold the particle half mask in position over the nose and mouth, pull the ear loop behand the ears.
③ Using both hands, form the nose clip around the nose and shift the ear loop to ensure a positive face seal.
④ Fit check:
a) To test the fit of the particle half mask without an exhalation vavel, cup both hands over mask and inhale sharply.
b)  If air flow is felt in the nose area, re-adjust/tighten the nose clip.
c) If are flows is felt around the edges of the respirator, re-positon the particle half mask/ear loop to achieve a better fit.
⑤ Change the mask immediately if breathing becomes difficult or mask becomes damaged or distorted.
⑥ Change the mask if a proper face seal can not be achieved.
⑦ Careful observance of these instruction is an important step in safe respirator use.

USE LIMATION

① Do not use the respirator or enter or stay in a contaminated area under the following circumstance:
a）.Atmosphere contains less than 19.5% oxygen.
b）.If you smell or taste contaminant.
c）.For protection against gases or vapors.
d）.Contaminants or their concentrations are unknown or immediately dangerous to life or health.
e）.For sandblasting, paint-spray operations and asbestos.
f ）.In explosive atmospheres.
② Do not modify or misuse the mask.
③ Do not use the particle half mask with facial hair or any other conditions that may prevent a good face-seal, the requirements for leakage will be achieved.
④ Particle filtering half mask need to be inspected prior to each use to assure there are no holes in the breathing zone other than punctures around and staples and no damaged has occurred. Enlarged holes resulting from ripped or torn filter material around staple punctures are considered damage.
⑤ This respirator helps protect against certain particulate contaminants but does not eliminate exposure to the risk or contracting disease or infection. Misuse may result in sickness or death.
⑥ This particle half mask marked “NR”, shall not be used for more than one shift.
⑦ This particle half mask is not suitable for users has an ear that has been damaged.

Manufacturer: Shandong Shengquan New Materials Co, Ltd.
Address: Diaozhen Industrial Development Zone, Zhangqiu District,
Jinan, Shandong, China
Service hotline: 0086-400-777-8118